Clear-Com VOICE2 - Manual (Page 37)

Vitec Group Communications
VoICE IP Interface User Manual 2 - 1 7
Configuring the Client VoICE unit
After completing the previous steps for the Server and the Client, the
basic set-up for each is completed and they are working on the LAN.
It is now necessary to configure the Client to connect to the Server and
complete the initial setup.
1. Open Browser
2. Enter the Client’s IP Address in the Address Bar.
3. You should see the Client’s main configuration screen:
Figure 2-27: Client Configuration Screen
Select the ‘Configuration’ and then ‘Voice’ tab to open the
configuration screen.