Clear-Com VOICE2 - Manual (Page 42)

Vitec Group Communications
VoICE IP Interface User Manual
3 - 2
6. Open a web browser on a PC that is in the same network as the unit
and enter its IP address in the address bar. (see page 2-13)
Now you can configure your unit. See the following section for more
information on the web interface.
CONFIGURING VOICE
This section will describe each web page on the Interface and each
page’s key functions. The Interface can be accessed via your web
browser through use of a computer connected to the VoICE or to the
same network as the VoICE.
Note that the IP default address can be reset - see “Reset IP
addresses to default” on page 25.
In order to connect two together for the first time, you need to do the
following (if you want more details, see the subsections below):
1. Power one unit up.
2. Open a web browser on a PC that is in the same network as the unit
and enter the unit IP address in the address bar.
The factory default network address is 172.16.86.100 unless the
unit has been factory preconfigured with 172.16.86.101 for a server
and 172.16.86.102 for a client.
3. Click on the LAN #1 tab and configure the proper network
parameters. Click on the Submit button when done. Make sure you
change at least the network address of one of the two units.
4. Enter the new network address in your web browser address bar.
5. Power second up.
6. Repeat steps 2 to 4.
7. Decide which one of the will be the client. Click on its ‘Configuration’
then ‘Mode’ tab, select Client mode and enter the other ’s network
address in the Server IP text box. Click on the Submit button when
done.
There are three main tabs: Configuration, Status and Admin.
CONFIGURATION TAB
The configuration tab consists of 4 subtabs for the different module
Configurations:
1. Network
2. VoICE
3. Data
4. Advanced
Note
Factory default address
is 172.16.86.100.
Factory set default
server address is
172.16.86.101.
Factory set default
Client address is
172.16.86.102.