Clear-Com VOICE2 - Manual (Page 65)

Vitec Group Communications
VoICE IP Interface User Manual 3 - 2 5
RESET IP ADDRESSES TO DEFAULT
If at some point in time the IP addresses of both Lan #1 and Lan #2 are
unknown, you can follow these instructions to reset them to the factory
default.
1. Connect a straight through (not cross-over) CAT-5 cable between
the "To Matrix" port 1 with the "To Panel" port 4 of the same unit
forming a loopback.
Figure 3-19: IP Reset Cable Setup
2. Reboot the unit by pressing and holding the power button for five
seconds to turn it off and then pressing the power button again to
turn it on or by removing power and reapplying power.
3. Remove the cable after the reboot.
4. The LAN1 IP will be 172.16.86.100 and LAN2 will be 10.0.0.1.
Refresh This button is pressed to refresh the content of the
Log Window.
LOGS TAB ITEMS