Clear-Com VOICE2 - Manual (Page 33)

Vitec Group Communications
VoICE IP Interface User Manual 2 - 1 3
Changing the IP address of the VoICE 2.0 unit
Perform this operation for all of your units, giving them each a
separate, unique IP address.
1. Start your web browser.
2. Enter into the Address Bar “10.0.0.1”
Figure 2-21: Web Interface
3. Click GO
4. You will be prompted for a Username and a Password. The default
username is ‘admin’ and the default password is ‘password’.
Username = admin
Password = password
You should now see the main configuration page
Figure 2-22: Main Configuration Page
5. Click on the LAN #1 tab
6. Change the IP address, Subnet mask, default gateway and DNS
server of the to the values supplied by your network administrator.
Use the values recorded in the Network Settings table (see above).
If you are configuring the Client then follow the first table. If you are
configuring the Server then follow the second table.
It is quite normal that the DNS server could be blank.
If you have no default gateway and both units are on the same LAN