CONTREX ML-Drive - Manual (Page 105)

4 - 3
DIAGNOSTICS
This section describes how to use the diagnostic routines to verify that the ML-Drive is
operating properly as well as to identify any ML-Drive problems. The diagnostic
routines are run independently, with the ML-Drive temporarily disconnected from your
system. Begin diagnostics with the Clear/4 procedure, then run tests 1-5. Each of the
tests can be performed without repeating the Clear/4 procedure, unless you exit
diagnostics.
If you need to verify the integrity of the ML-Drive relative to your system, refer to the
Troubleshooting: Troubleshooting section, page 4-11. If the information in this section
does not solve your problem, consult:
Contrex Technical Support (763) 424-7800 or 800-342-4411
Clear/4 - To Begin the Diagnostic Procedure
To begin the diagnostic procedure, turn the ML-Drive off and disconnect it
from your system.
Turn the power on the ML-Drive while simultaneously pressing “Clear” and
“4” on the keypad.
The ML-Drive defaults to RAM Test #1. The Diagnostic indicator and the
number “1” are visible on the left side of the LED display. If you did not see
this indicator, you are not in diagnostics. The example below shows the
diagnostic indicator and test number on the LED display.
Diagnostic Indicator
Test Number