CONTREX ML-Drive - Manual (Page 129)

Glossary - 9
Output Test Tests the Logic Outputs.
Outputs Drive Out (J2 pins 1, 2)
Drive Enable (J4 pin 16, 18)
Alarm (J4 pin 17, 18)
Parameters Parameters are divided into two classifications; Control
Parameters (CP) and Monitor Parameters (MP).
Parameter Code The numbered code that represents a Parameter.
Parameter Send Use the Parameter Send to change any of the ML-Drive's
Control Parameters in Serial Communications.
Parameter Value Parameter values are pre-loaded in the factory, however,
you can modify Control Parameter values with operational
data that is unique to your system.
Performance Monitoring Tach
Deviation (Error)
Scaled Reference
Ramped Reference
Trim Output
PROM Chip The PROM (Programmable Read Only Memory) chip is
the software for the ML-Drive. This is not to be confused
with the EEPROM (which is were the default Control
Parameters and Monitor Parameters are stored).
PROM Test One of the two power up diagnostic routines that the
ML-Drive automatically performs during every Power Up.
PPR Feedback See Appendix C; CP-31.
PPR Lead See Appendix C; CP-30.