CONTREX ML-Drive - Manual (Page 150)

C - 14
MP-83 CURRENT LIMIT STATUS
Current Limit Status (MP-83) displays the present status of the current limit. When the ML-Drive
is current limiting, then the number “1” is displayed. When the ML-Drive is not in current limit,
then the number “0” is displayed.
CP-98 KEYPAD LOCKOUT
Keypad Lockout (CP-98) displays the present status of the keypad lockout. When the keypad is
locked, then “LOC” is displayed. When the Keypad is unlocked, then “ULOC” is displayed. To
lock out the keypad, enter a numerical “password” between “1” and “9999” in Keypad Lockout
(CP-98). This numerical password will flash briefly on the screen, then the screen will display
“LOC”. To unlock the keypad, enter the same numerical password in Keypad Lockout (CP-98).
The number will flash briefly on the screen and then the screen will display “ULOC”. Control
Parameters and Monitor Parameters may be monitored during lockout, however, Control
Parameters can not be changed during lockout. The Clear/7 procedure will default Keypad
Lockout (CP-98) to “ULOC” (unlocked).
CAUTION: Make certain that you record your password, as it becomes transparent once you
have entered it. If you forget your password, you can use the Clear/7 procedure to
revert back to the default “ULOC” (unlocked). Please note, however, that the Clear/7
procedure will revert all of the Control Parameters back to their original default
values and you will lose any changes that you have made to the Control Parameters.
Therefore, make certain that you have recorded all Control Parameter changes in the
space provided in Appendix D before you use the Clear/7 procedure. Refer to
Troubleshooting:Troubleshooting , page 4-11 for instructions on the Clear/7 proce-
dure.
MP-99 SOFTWARE CODE REVISION
Software Code Revision (MP-99) displays the code revision number of the ML-Drive software
(PROM).
MP-00 SOFTWARE PART NUMBER
Software Part Number (MP-00) displays last four digits of the software part number for the
ML-Drive. The first four digits of the part number are assumed to be “1000”.