PSA PIN388D/PIN388L Installer Manual - Manual (Page 10)

PINKERTON Installer Manual 9
P ROGRAMMING – L OCAL & D IALLER VERSIONS
B INARY A DDRESSES
Most programming addresses are Yes/No type addresses. The obvious exceptions are T
ELEPHONE
N UMBERS , A CCOUNT N UMBERS , T IMERS , etc, where a value is directly entered rather than
selecting yes or no.
Binary Addresses are also called Yes/No options.
When a Yes/No option is selected the state of the 8 options is displayed on the 8 Zone lights.
•
The light ON means that the option is turned on.
•
The state of each option may be toggled by pressing the relevant digit key from

to
.
•
The key turns ON all options and the

key turns OFF all options.
•
When the eight options are programmed as required simply press to allow another 3 digit
address to be selected or press

to advance to the next address.
•
Pressing

displays the current address being edited.
Example
Programming Z
ONE O PTIONS for Zone 1
....................................To clear the keypad

..................... Factory default Installer Code

.................................... To enter program mode

........................... Address for Zone 1 options
The keypad lights will appear as below. At this stage, press any key from  to to toggle on or off
the relevant option. The factory default settings for Zone 1 are shown in the example below.