PSA PIN388D/PIN388L Installer Manual User Manual
Page 31
30
PINKERTON Installer Manual
P
ROGRAMMING
–
D
IALLER VERSION
D
ECIMAL
A
DDRESSES
O
VERVIEW
Decimal options are selected by their start address. For example the primary telephone number is
selected by address 128. When a decimal option is first selected, all digits of the option are
displayed in sequence in the same manner as the display address option. If displaying a telephone
number then the display terminates if it encounters a "15". (end of telephone number).
D
ISPLAYING DIGITS
While displaying the digits, (each digit for 1.5 secs) the O
N
-L
INE
, B
ATT
, P
OWER
and O
N
lights
will turn on sequentially, one at a time as each new digit of the option is displayed. (If the decimal
option is only a single digit option the "sequential display" is skipped). If any key is entered whilst
displaying decimal data, the rest of the display sequence is skipped.
E
NTERING
D
IGITS
Once all the digits are displayed, all Zone lights will momentarily light and the display will revert
to normal entry mode, starting at the start address of the selected decimal option. New data may
now be entered by simply typing the required digits. Each digit entered can range from 0 to 15. As
each digit is entered it will momentarily be displayed before advancing to the next address and
displaying its contents.
Enter
to show what address you are up to.
Enter
to advance to the next address.
When the required number of digits (or
) has been entered, the
system
will revert back to
address entry mode.
Technical Note
If installing a dialler panel and the telephone line is not being connected, you must default the
panel to local format. If the panel is not defaulted you may experience difficulties disarming the
panel when in alarm. This is due to the alarm panel attempting to detect the telephone line. As a
result, the keypad will not accept any codes. This situation can be rectified by connecting a
telephone line or default for local.
P
ROGRAMMING
T
IP
:
When you access any decimal address, the existing data will be displayed first as described above.
It is not necessary to wait for the display to finish. The data display can be interrupted by pressing
the
key or simply by entering the new data.
Use of the
key for decimal addresses