PSA PIN388D/PIN388L Installer Manual - Manual (Page 29)

28 PINKERTON Installer Manual
N
ON
-Z
ONE
I
NPUTS
OPEN / CLOSE INPUT (Address 064)
The "Open/Close" input is designed to send opening and closing reports to the monitoring station
when the panel is turned on and off. If enabling, select Dialler and 24hr options only.
FAIL TO COMMUNICATE INPUT (Address 066)
The Fail to Communicate input is intended to trigger the sirens and strobes if the dialler fails to
establish contact with the monitoring station after the number of attempts set by address 242.
DURESS, PANIC & TEST INPUTS
The DURESS, PANIC and TEST functions are all physical inputs to the Panel. As with Zone
inputs, they can be triggered by connecting a switch of some kind directly to the panel. These
physical inputs are in addition to the eight alarm Zones: They are accessed by three terminals on
the Panel PCB and, like the Zone inputs, require 4.7K resistors to be fitted if used.
NOTE: Duress, Panic and Test are simply labels assigned by the Ademco High Speed reporting
format. Duress, Panic or Test buttons can be connected to any of the eight Zone inputs and will
perform in a similar manner.
DURESS INPUT (Address 086)
The Duress terminal on the panel PCB is programmed the same as any Zone input. The Duress
function is also available as a keypad function if the input is first enabled.
PANIC INPUT (Address 088)
The Panic terminal on the panel PCB is programmed the same as any Zone input. The Panic
function is also available as a keypad function if the input is first enabled.
TEST INPUT (Address 090)
The Test terminal on the panel PCB is programmed the same as any Zone input. The Test function
is also available as a keypad function if the input is first enabled.
LOW BATTERY (Address 092)
This input transmits low battery when the battery voltage is below 11.5 volts. Normally
programmed to trigger the dialler only.
AC FAIL (Address 094)
This input is normally programmed to trigger the dialler only.