PSA PIN388D/PIN388L Installer Manual - Manual (Page 17)

16 PINKERTON Installer Manual
S IREN O UTPUT
T URNING SIREN ON.
Any active input can be programmed to trigger the siren. When in Home Mode, there is a separate
option for enabling sirens for any Zone, see: Zone Options Section 2.
Note that Zones with the siren lockout option set for that Zone can only trigger the siren once
during any one armed period. Note that panic, test and duress key sequences simply trigger the
respective inputs and will only sound the siren if the siren is enabled for those inputs.
If address 240, option 7 is on, the siren can be toggled on and off by triggering Zone 7. See page
26.
T URNING SIREN OFF.
• Siren will turn off at the end of siren time; which is set by address 104. Siren time can be set
between 01 and 99 minutes and is accurate to about 1 second/minute.
• Siren can be toggled off by triggering Zone 7 only if it was turned on by Zone 7. If an alarm
Zone turned the siren on, Zone 7 will not turn the siren off. This is valid only if address 240,
option 7 is on.
• Siren will turn off if low battery is sensed. If low battery is sensed at any time, the strobe and
siren will be turned off if they are on. This reserves battery power for the dialler.
• Siren will turn off when a valid user code turns the panel off.
If Fail To Communicate (address 066) is programmed to sound the siren, it will only sound the
siren when the dialler has made the programmed number of attempts to communicate. If an open
or close report fails to communicate, the siren will not be triggered.
S
TROBE
O
UTPUT
T URNING S TROBE O N :
Any active input can be programmed to trigger the strobe. When in Home Mode there is a
separate option for enabling the strobe for any Zone, see: Zone Options Section 2.
Note that panic, test and duress key sequences simply trigger the respective inputs and will only
trigger the strobe if the strobe is enabled for those inputs.
T URNING S TROBE O FF :
• Strobe will turn off when a valid user code turns the panel off.
• By low battery being sensed. If low battery is sensed while the strobe is on, it will be turned off
immediately. The siren will also be turned off if it is on. This reserves battery power for the
dialler.