PSA PIN388D/PIN388L Installer Manual User Manual
Page 21
20
PINKERTON Installer Manual
C
HANGING
Z
ONE
C
ONFIGURATIONS
Example – Programming Zone 1 for Entry Delay
Section 1.
Section 2.
1. Enter Installer Code
2. Press the
key (The On-Line light will now flash).
3. Enter
(Section 1 three digit address).
4. Pressing each number on the keypad will turn the respective Zone
LED on or off. Proceed to press each Zone number so the diagram
to the left (Section One)represents the keypad.
5. Having completed step 4 press the
key once. This will allow
you to enter the three digit address for Section 2 (224).
6. Enter
(Section 2 three digit address).
7. Pressing each number on the keypad will turn the respective Zone
LED on or off. Proceed to press each Zone number so the diagram
to the left (Section Two) represents the keypad.
8. Enter
to cancel the programming mode.
• To program zones 2 – 8 follow the same procedure as above using
the Section 1 and Section 2 table on the previous page.