PSA PIN388D/PIN388L Installer Manual - Manual (Page 7)

6 PINKERTON Installer Manual
D EFAULTING THE PINKERTON S YSTEM
Setting the installer code to factory default of 2580
There are two ways of defaulting the SYSTEM:
1. Defaulting only the installer code.
To default the INSTALLER CODE only, simply power up the panel with the KY input
shorted to D-. Wait 5 seconds. Remove the KY short to D-. The installer code is now
defaulted to 2580. (If address 255 was set to "9" then no code change was made)
2. Setting all panel options back to a factory default.
To set the PINKERTON options back to factory default, use the installer code to go into
programming mode and set lights at address 250 (Yes/No option) as below. The below
options will automatically be set to one of four factory defaults and the SYSTEM will then
initiate a self reset.
Factory Default Options
Default 1, Local Format (Address 250, enter 1,5,7,8) (Factory Default for Local SYSTEM)
Local default disables all dialler functions allowing the panel to operate in local mode (sirens and
strobe only). Can be very handy as an aid during installation. Whilst in local format, the Pinkerton
system can still answer the phone as long as Required Rings (address 168) is not set to zero.
Default 2, Personal Reporting (Address 250, enter 2,5,7,8) (Factory Default for Dialler
SYSTEM)
Personal reporting allows dialler reports to be sent to any telephone including mobile phones.
When triggered, the alarm system will immediately seize the line and dial the pre-programmed
number. The system will then output an alternating high/low siren type sound to indicate that an
alarm has occurred.
Default 3, Domestic Monitored (Address 250, enter 3,5,7,8)
The domestic monitored default programs the panel for back to base reporting with Open / Close
reports disabled.
Default 4, Business Monitored (Address 250, enter 4,5,7,8)
The business monitored default programs the panel for back to base reporting with all dialler
functions enabled.
See the Programming Quick Reference, for a summary of pre-programmed options for the four
default types.
Important: After address 250 is programmed, all system configurations will
revert back to the respective factory default values.