Teledyne 3010TB - Split architecture trace oxygen analyzer - Manual (Page 74)

3 Installation Model 3010T
3-6: Part II
Teledyne Analytical Instruments
Figure 3-4: Control Unit (CU) to Analysis Unit (AU) Connector Cable
If you use your own gas control valves, use the interconnect diagram in
Figure 3-5 for the valves. The sensor and thermistor remain connected as in
Figure 3-4, above. (See drawing D-64949 for wire recommendations.)
Figure 3-5: Remote Probe Connector Pinouts
Thermistor
Block
Sensor
Block
Thermistor 1
Thermistor 2
Sensor Return (-)
Sensor Hot (+)
Sensor Signal 8
Sensor Signal 2
Sensor Signal 1
Sensor Signal 7
Solenoid Valve 3
Sample In
+
-
-
+
+
-
+
-
+15 V dc
Span (return)
Sample (return)
Zero (return)
+15 V dc
+15 V dc
Exhaust (return)
+15 V dc
Exhaust
Zero In
Span In
Solenoid Valve 4
Solenoid Valve 9
Solenoid Valve 10
Solenoid Valve 5
Solenoid Valve 6
Solenoid Valve n/a
Solenoid Valve n/a
CU
AU