Teledyne 3010TB - Split architecture trace oxygen analyzer User Manual
Page 76
Advertising
3 Installation
Model 3010T
3-8: Part II
Teledyne Analytical Instruments
•
Check the integrity and accuracy of the gas connections. Make
sure there are no leaks.
•
Check the integrity and accuracy of the electrical connections.
Make sure there are no exposed conductors
•
Check that sample pressure is between 3 and 40 psig, according
to the requirements of your process.
Power up the system, and test it as follows:
1. Repeat the Self-Diagnostic Test as described in Part I, chapter 4,
section 4.3.5.
Advertising