AMX G3 - Manual (Page 128)

120 AXCESS Programming Color Active-Matrix LCD Touch Panels
System Send_Commands (cont.)
Command Description
'AKEYP-<number
string>' Open the Touch Panel keypad and initialize the number string
entry. The keypad string is set to null during power-up and is
stored until power-down.
<number string> = 0 - 9999
Example:
SEND_COMMAND TP,'AKEYP-1988'
Opens the Touch Panel keypad with 1988 in the display.
'AKEYR'
Close the Touch Panel keyboard or keypad opened with the
'AKEYB', 'AKEYP', or 'PKEYP' commands.
Example:
SEND_COMMAND TP,'AKEYR'
Closes the keyboard or keypad opened using the 'AKEYB' ,
'
AKEYP'
, or '
PKEYP'
commands.
'BEEP' Output one beep. The Beep button in the Protected Setup
page must be set to 1 - 10 for this command.
Example:
SEND_COMMAND TP,'BEEP'
Beeps the panel if the Beep button is not set to 0.
'BRIT=<level>' Adjust brightness of display. The brightness range is 1
(minimum) to 8 (maximum).
<level> = 1 - 8
Example:
SEND_COMMAND TP,'BRIT=8'
Sets to highest brightness level.
'CALIBRATE'
Start Touch Panel calibration.
Example:
SEND_COMMAND TP,'CALIBRATE'
Starts the calibration operation on the Touch Panel.