AMX G3 - Manual (Page 98)

90 Touch Panel Program Reference Color Active-Matrix LCD Touch Panels
— GENERAL Sets the button to automatically send a message to the
AXCESS Central Controller via the AXlink connector, PC via the factory
installed port connector, or with WAVE wireless communication. Refer to
Properties Page— Button Type: General in this section for more information.
— JOYSTICK Sets the button to a joystick that includes a control stick.
When you move the control stick, the Touch Panel sends feedback (data) to
the control system and to the external device to perform a pre-programmed
operation. Refer to Properties Page— Button Type: Joystick in this section for
more information.
— VERTICAL BARGRAPH Sets the button to a vertical bargraph or slider.
Feedback for bargraph or slider response comes from the control system.
Refer to Properties Page— Button Type: Vertical Bargraph in this section for
detailed information.
— HORIZONTAL BARGRAPH Sets the button to a horizontal bargraph or
slider. Feedback for bargraph or slider response comes from the control
system. Refer to Properties Page— Button Type: Horizontal Bargraph in this
section for detailed information.
— BRIGHTNESS Sets the button to open the Brightness page shown in
Figure 156. The Brightness page allows you to set the Touch Panel’s LCD
light level. The minimum brightness setting is 1 and the maximum is 8.
Figure 155
BUTTON TYPE menu