Ransburg, Disassembly procedures, Step 5 step 6 step 7 – Ransburg Aerobell 168 Atex Approved 13350 User Manual
Page 57
Advertising
DISASSEMBLY PROCEDURES
(15mm Bell Cup and Shape Air Ring)
Step 5
Step 6
Step 7
Remove Shape Air Ring. Pull
straight off.
Note: The Shape Air Ring is sealed
with a O-ring and may be difficult to
remove.
Note: When reassembling an audible
“Click” should be heard.
Note: The Shape Air Ring has a blue
alignment mark . The blue alignment
mark will line up with the yellow dot
located on the At-omizer Body and the
small yellow line located on the Tur-
bine. All three (3) alignment marks will
have to be in line when assembling.
Note: Two (2) locating pins are
mounted on the back of the Shape
Air Ring to insure proper alignment.
Yellow Dot
Yellow Line
Blue Line
Aerobell 168 - Maintenance
Ransburg
LN-9247-13
54
Advertising