Ransburg, Disassembly procedures, Step 5 step 4 – Ransburg Aerobell 168 Atex Approved 13350 User Manual
Page 66
Advertising
Step 5
Step 4
DISASSEMBLY PROCEDURES
(65mm Bell Cup and Shape Air Ring)
Remove the Cup Wash Fitting
from the Shape Air Ring.
When assembling the Cup Wash
Fitting, tighten with fingers until
an audible “click” is heard.
Note: Be careful not to drop the
Cup Wash Ferrule.
Make sure when assembling
the Cup Wash Fitting that the
ferrule taper end is inserted
into the Cup Wash Fitting.
Insert the Bell Cup Removal
Tool(A12899) in the hole located
on the Shape Air Ring and align
with the hole in the Turbine Shaft.
Aerobell 168 - Maintenance
Ransburg
LN-9247-13
63
Advertising