Ransburg Aerobell 168 Atex Approved 13350 - Manual (Page 61)

Step 4
Step 5
DISASSEMBLY PROCEDURES
(30mm Bell Cup and Shape Air Ring)
Remove the Cup Wash Fitting
from the Shape Air Ring.
When assembling the Cup Wash
Fitting, tighten with fingers until
an audible “click” is heard.
Note: Be careful not to drop the
Cup Wash Ferrule.
Make sure when assembling
the Cup Wash Fitting that the
ferrule taper end is inserted into
the Cup Wash Fitting.
Remove Shape Air Ring.
Pull straight off.
Note: The Shape Air Ring is
sealed with a O-ring and may be
difficult to remove.
Note: When reassembling an au-
dible “Click” should be heard.
Aerobell 168 - Maintenance
Ransburg
LN-9247-13 58