Teledyne LeCroy PETracer Summit and Summit T2-16 PCIe User Manual - Manual (Page 172)

Chapter 9: BitTracer Recording Summit User Manual
164
Teledyne LeCroy
9.13 Packets Bar
The Packets report window summarizes packet types detected in the file.
To obtain packet types, you must perform a post-capture "Analyze" step. After capture,
when you open the Packets Bar for the first time, items can display the command
"Analyze". To start the analysis, click the word Analyze. After analysis finishes, the
results are saved with the file. Therefore, you do not need to click Analyze the next time.

Note: The table entries are hyperlinks.
Note: If you edit anything, the results are no longer valid, and the system requires you to
click Analyze again.
After analysis, the Packets Bar looks like the following: