Teledyne LeCroy PETracer Summit and Summit T2-16 PCIe User Manual - Manual (Page 37)

Summit User Manual Chapter 3: Installation and Setup
Teledyne LeCroy
29
3.4 Setting Up the PETracer Summit Analyzer
Step 1 Remove the Analyzer from its shipping container.
Step 2 Connect the Analyzer to a 100-volt to 240-volt, 50 Hz to 60 Hz,
120 W power outlet using the provided power cord.
Note: The Analyzer is capable of supporting supply voltages between 100 volts
and 240 volts, 50 Hz or 60 Hz, thus supporting all known supply voltages around
the world.
Step 3 Connect the Ethernet cable between the Ethernet port on the back of the
Analyzer and a Ethernet port (hub, switch or wall) in your local network.
Step 4 Turn on the rear power switch and the front power switch.
Note: At power-on, the Analyzer initializes itself in approximately five seconds
and performs an exhaustive self-diagnostic that lasts about fifteen seconds. The
results are reflected by messages on the PETracer Summit LCD display (see
“PETracer Summit Front Panel Description” on page 13). If the LCD display
indicates failure, call Teledyne LeCroy Customer Support for assistance.
Note: No driver installation is needed for the PETracer Summit device.
Connecting to a PETracer Summit Analyzer in the
Local Network
After you have installed the PETracer application software, perform the following
procedure to connect to a PETracer Summit analyzer in the local network.
Step 1 Select the Setup > All connected devices… menu in the PETracer
application to display the Analyzer Devices dialog.
The PETracer software fills the list with devices that are connected over USB or
discovered on the Ethernet network. The discovery mechanism works only within
one network subnet. If a Summit is connected to the network on a different
subnet, you can manually add the subnet to the list by clicking the Add Device
button and specifying the IP address.