Summit t2-16 setup menu – Teledyne LeCroy PETracer Summit and Summit T2-16 PCIe User Manual User Manual
Page 20
Chapter 2: Hardware Description
Summit User Manual
12
Teledyne
LeCroy
Summit T2-16 Setup Menu
Menu
Submenu
Command
IP Mode
Static
Dynamic
Static = You assign an IP address.
Dynamic = A DHCP server assigns an IP address.
IP Address
If IP Mode = Dynamic, this field is ignored.
Subnet Mask
Default is 0.0.0.0
If IP Mode = Dynamic, this field is ignored.
Default Gateway
Default is 0.0.0.0
If IP Mode = Dynamic, this field is ignored.
Reboot
Cancel
Confirm
Selecting Confirm causes Summit to save the
current configuration and reboot.
Shutdown
Cancel
Confirm
Selecting Confirm causes Summit to save the
current configuration and shut down.
About
Displays status on the following parameters:
• Subnet Mask
• Default Gateway
• BootCode
• Firmware
• Bus Engine
• IP Mode: Dynamic or Static
Note: To go back to the previous menu, press the
Select button (middle button).
[Back]
Returns to the Root menu.