Teledyne LeCroy PETracer Summit and Summit T2-16 PCIe User Manual - Manual (Page 24)

Chapter 2: Hardware Description Summit User Manual
16
Teledyne LeCroy
2.5 Summit T2-16 Rear Panel Description
From left to right, the Summit T2-16 rear panel contains the following components:
Figure 2.1 Summit T2-16 Rear Panel
Wide-range AC Connector Module
• Power on/off switch
• Enclosed 5x20 mm 2.0A 250 V fast acting glass fuse
• Power socket
Warning! For continued protection against fire, replace fuse only with the type and
rating specified above.
Sync In and Sync Out Connectors
(not currently active) These connectors allow multiple Summit T2-16 analyzers to send
synchronization and control messages to one another.
USB Type B Host Machine Computer Connector
This connector links an Analyzer to the host machine for the purpose of transmitting
commands from the host machine to the Analyzer and uploading traces from the
Analyzer’s recording memory to the PETracer software for viewing and analysis.

Note: For each Analyzer or Exerciser, use either USB or Ethernet, not both.
Ethernet Port
GIGE Connectivity allows connection to an Ethernet network and sharing of analyzer
resources by multiple engineers. Note: For each Analyzer or Exerciser, use either USB
or Ethernet, not both.
BNC Connectors Trigger In and Trigger Out
These BNC connectors allow the Analyzer to transmit or receive trigger event signals. 
Triggering: The Ext. In can receive a signal from another device and use that signal to
trigger the end of the recording. Conversely, the Ext. Out connector can be used to send
an output signal from the Analyzer to another device.
The BNC connectors are not used for the PETrainer Exerciser.