Teledyne LeCroy PETracer Summit and Summit T2-16 PCIe User Manual - Manual (Page 36)

Chapter 3: Installation and Setup Summit User Manual
28
Teledyne LeCroy
3.3 Setting Up the Summit T2-16 Analyzer using a
USB Connection
To set up the Analyzer using a USB connection:
Step 1 Remove the Analyzer from its shipping container.
Step 2 Insert and install the Installation CD.
Step 3 Connect the Analyzer to a 100-volt to 240-volt, 50 Hz to 60 Hz,
120 W power outlet using the provided power cord.
Note: The Analyzer is capable of supporting supply voltages between 100 volts
and 240 volts, 50 Hz or 60 Hz, thus supporting all known supply voltages around
the world.
Step 4 Connect the USB port to a USB port on the host machine using a USB
cable.
Note on Ethernet: To connect using Ethernet, see “Setting Up the Summit T2-16
Analyzer using an Ethernet Connection” on page 25.
Step 5 Turn on the rear power switch and the front power switch.
Note: At power-on, the Analyzer initializes itself in approximately five seconds
and performs an exhaustive self-diagnostic that lasts about forty seconds. The
results are reflected by messages on the Summit T2-16 LCD display (see
“Summit T2-16 Front Panel Description” on page 10). If the LCD display indicates
failure, call Teledyne LeCroy Customer Support for assistance.
Step 6 Click Next after you see the Add New Hardware Wizard window.
Step 7 Follow the Microsoft ® Windows ® on-screen Plug-and-Play instructions
for the automatic installation of the Analyzer as a USB device on your
analyzing host machine. (The required USB files are included on the
Installation CD and were installed on your system when you installed the
software CD.)
Step 8 Click Finish when you see the message that says “Windows has
finished installing the software that your new hardware requires” and the
file has been installed in your host machine.
Warning! Do not change from USB to Ethernet, or back, without power cycling
the analyzer.