Teledyne LeCroy PETracer Summit and Summit T2-16 PCIe User Manual - Manual (Page 19)

Summit User Manual Chapter 2: Hardware Description
Teledyne LeCroy
11
LCD Menus
The Summit T2-16 has a front LCD panel that displays menus with commands for
configuring the device.
Boot Sequence
The boot sequence for the analyzer takes a few seconds. As the analyzer boots, it
initializes itself, beeps, and shows the status on the LCD panel. If the analyzer boots
successfully, the LCD panel Root menu appears.
During initialization, the LCD panel displays boot status messages.
Booting from Boot-Code
If the analyzer does not boot successfully, or if it becomes non-responsive, you can boot
from default settings called boot-code.
Boot-code is a simplified version of Summit firmware. It allows the analyzer to boot to the
point where it can communicate with the Summit software application. After
communication is established between the analyzer and software application, you can
download a different version of firmware and BusEngine files to the analyzer.
To boot from boot-code:
Step 1 Press and hold the Manual Trigger button on the analyzer front panel.
Step 2 While holding the button DOWN, turn the box ON.
After you complete these steps, download the new version of BusEngine and firmware
files, then reboot the analyzer from the LCD panel menu (Summit Setup > Reboot).
Root Menu
The Root menu appears after successful boot-up. The top line of the Root menu displays
the device status with the following:
• [PCI]: Indicates the hardware platform.
• Idle: Shows analyzer status.
Submenus
The Root menu has these options:
• Summit Setup menu: Allows setup using submenus.
• Platform Status menu: Shows the results for the power-on self-diagnostics.
Note: When lists of options are presented in a menu, the current selections are
indicated with an asterisk.
To navigate, use the Up Arrow and Down Arrow buttons (top and bottom blue buttons)
on the front of the unit.
To select or change an option, use the Select button (middle blue button).