Teledyne LeCroy SAS Suite User Manual - Manual (Page 204)

Version 6.25 SASSuite User Manual
194
LeCroy Corporation
Configuring the Connection
Once you have completed the physical setup, you are ready to configure the analyzer
connection.
USB
Connected
Analyzers
Configuration for two or more USB connected analyzers is minimal.
In the following example, two SASTracer analyzers are linked via USB to a host PC. You
connect to one of the two analyzers.
Step 1 Start the SASTracer analyzers and the SASSuite software.
Step 2 From the menu, select Setup > All Connected Devices.
The Analyzer Network dialog box opens. To select an analyzer, check
the relevant checkbox on the left.
Step 3 Click Close.
The dialog box closes and the analyzer is selected. The SASSuite
software on your screen will now control the selected analyzer.
Note: You can update the Firmware, BusEngine and License from this
dialog by checking an analyzer and then clicking the appropriate
button on the right. You can also directly open and set Recording
Options for any of the analyzers by checking one or more analyzers
and then clicking the Recording Options button. The Recording
Options dialog will open. The settings you create will apply to all
selected analyzers.