Teledyne LeCroy SAS Suite User Manual - Manual (Page 238)

Version 6.25 SASSuite User Manual
228
LeCroy Corporation
SASTrainer Generation Commands
General
Commands
IDLE (n) Generator will insert n idle dwords into gen stream
CLEAR_CREDIT_AVAIL This commands clears the credit established with the command
WF_CREDIT_AVAIL. (See WF_CREDIT_AVAIL in following section
on Wait Commands for explanation).
RD_POS Generator will insert one idle dword into gen stream, which will bring
current RD to positive level
RD_NEG Generator will insert one idle dword into gen stream, which will bring
current RD to negative level
RD_ERROR Generator will insert one idle dword into gen stream, which will
intentionally break RD sequence creating RD error
CONNECT Generator will go through connection sequence using current
GenFile settings (gen mode, speed e.t.c.) Generation will not
resume until connection is established
DISCONNECT Generator will break existing connection to DUT
PAUSE Generator will come to a break and the user will be able to resume
generation by pressing Resume button on Generation toolbar.
Generator shall transmit idle dwords while in the Pause.
OUTPUT_ON Takes the Trainer out of Electric Idle state. If it is already out of
Electric Idle, this is a NOP.
OOB Commands
COMINIT Generator will send COMINIT OOB signals using current COMINIT
settings.
COMRESET Generator will send COMRESET OOB signals using current
COMRESET settings.
COMWAKE Generator will send COMWAKE OOB signals using current
COMWAKE settings.
COMSAS Generator will send COMSAS OOB signals using current COMSAS
settings.
SATA_ALIGN Generator will go through SATA_ALIGN stage of SATA SpeedNeg
process using current SATA_ALIGN settings.
SATA_D10_2 Generator will go through SATA_D10_2 stage of SATA SpeedNeg
process using current SATA_D10_2 settings.
SPEED_NEG_RCDT Generator will go through SPEED_NEG_RCDT stage of SAS
SpeedNeg process using current SPEED_NEG_RCDT settings.