Teledyne LeCroy SAS Suite User Manual - Manual (Page 295)

SASSuite User Manual Version 6.25
LeCroy Corporation
285
Probing
Character-
istics
Model SS002MAA & SS003MAA
Model SS004MAA
Recording
Memory
Size
2 GBytes for trace capture, timing and control information.
Host PC
Require-
ments
Switches
LEDs
Connector Type: One Port Model - Single Pair of Internal Connectors (Initiator and
Target; Serial ATA Standard)
Two Port Model - Dual Pair of Internal Connectors (Initiator and
Target; Serial ATA Standard)
Four Port Model - Single Pair of Internal Connectors (Initiator and
Target; Serial ATA Standard)
SASTrainer Connection
Type: Single Initiator and Target connectors
(for transmission only)
Connector Type: 2 pairs SAS External 4 lane Connector:
Non-intrusive tap - samples the signal without re-driving the
differential lines (high value resistors contribute to reduction in
amplitude ˜ 15%).
Repeater tap - re-drives the signal at either SAS (high swing) or
SATA (low swing) voltages; does not re-time the signal.
Operating System: Windows 98SE, Windows 2000, Windows ME or Windows XP
Power: On/off
Manual Trigger: When pressed, triggers the end of the recording
CATC 10K: Illuminated when the analyzer is powered on.
Status (STATUS): Illuminates for approximately 25 seconds during
initialization/power up of the CATC 10K base unit. If this LED
blinks following initialization, this is an indication that initialization
failed.
Recording (REC): Illuminated when the analyzer is actively recording traffic data
Triggered (TRG): Illuminated during power-on testing and when the analyzer has
detected a valid trigger condition.
UPloading (UPLD): Illuminated when the analyzer is uploading its recording memory
to the Host PC for displaying the CATC trace
SASTracer Plug-in
Module:
Status (STATUS): Illuminates when there is traffic on both the host and device
sides. Blinks when there is traffic on one side only.