Teledyne LeCroy SAS Suite User Manual - Manual (Page 205)

SASSuite User Manual Version 6.25
LeCroy Corporation
195
Remote
Analyzers
Over an IP
Network
To configure SASSuite to remotely control an analyzer over an IP LAN, you will need to
use the Analyzer Network dialog to browse to the host controlling the analyzer and add
both the host and its PC to the dialog.
Step 1 From the menu, select Setup > Analyzer Network.
The Analyzer Network dialog box opens. This dialog lists host PCs and
their analyzers. The listed devices are either currently connected or
were connected at some point previously.
Step 2 Remove any host (other than the Local Machine) from the list by
selecting the host and then clicking Remove.
You should keep in the list only the host(s) that you are planning to
immediately use.
Step 3 To add a host and analyzer to the list, click Add.
A browse dialog box opens.
Step 4 Browse to the host that has an analyzer attached to it and
double click on it.
Step 5 The host will be added to the Analyzer Network dialog.
Step 6 Click Close to close the dialog box.
Step 7 Select Setup > All Connected Devices ... to open the Analyzer
Devices dialog box.