Teledyne LeCroy SAS Suite User Manual - Manual (Page 22)

Version 6.25 SASSuite User Manual
12
LeCroy Corporation
Setting Up the Analyzer
Step 1 Remove the analyzer from its shipping container .
Step 2 Connect the analyzer unit to a source of compatible AC power
using the provided power cord (and, for Avalanche, the provided
external power supply).
Note: The analyzer is capable of supporting supply voltages
between 100-volt and 240-volt, 50 Hz or 60 Hz, thus
supporting all known supply voltages around the world.
Step 3 Turn on the power switch (on the front of the Avalanche or on the
rear of the CATC 10K).
Note: At power-on, the analyzer initializes itself in approximately
ten seconds and performs an exhaustive self-diagnostic
that lasts about five seconds. If the diagnostics fail, call
LeCroy Customer Support for assistance.
Step 4 Insert the CD into the CD ROM drive of the PC that will be
controlling the analyzer.
Step 5 Connect the USB cable between the USB port on the back of the
analyzer and a USB port on the PC.
The operating system detects the analyzer and begins to install the USB
driver.
Step 6 Follow Windows on-screen Plug-and-Play instructions for the
automatic installation of the analyzer as a USB device on the
Host PC (the required USB files are included on the SASSuite
CD). Step through the Windows hardware wizard. The wizard
will see that the analyzer has an internal USB hub and will begin
loading hub drivers. Afterwards, the wizard will automatically
install the system as a USB device on the PC. When the wizard
prompts you for driver information, point it to the CD which
should be in your disk drive and install the following files
•
For Avalanche systems, install Avalnche.sys and CTCDragn.sys
•
For SASTracer systems, install CATCupa.sys and SasTracer.sys.