Vanguard WRM-40 User Manual
Page 18
WRM-10P AND WRM-40 USER’S MANUAL
REV 3
14
3.0 OPERATING
PROCEDURES
3.1
WRM Cable Connections
Typical WRM connection diagrams are shown in Figure 7, Figure 8, Figure 9, and Figure 10.
WARNINGS
• Do not touch or disconnect any test lead that is connected to a transformer
terminal while high current is being conducted during a test. Failure to heed
this warning can result in lethal electric shock to personnel and/or damage
to the equipment.
• Disconnect the test clips from the transformer bushing only after the WRM
has completely discharged the transformer. Always disconnect the test clips
slowly from the transformer bushing to prevent an accidental flash-over.
Figure 7. Typical WRM Connections Diagram #1
Figure 8. Typical WRM Connections Diagram #2