Vanguard WRM-40 User Manual
Page 35
REV 3 WRM-10P AND WRM-40 USER’S MANUAL
31
g. The following screen will be displayed:
Use the
[PAPER ∧ Contrast]
and
[PAPER ∨ Contrast]
keys to adjust the D.U.T.
(Device Under Test) temperature.
Press the
[ENTER]
key to confirm the D.U.T. temperature setting.
h. The following screen will be displayed:
Use the
[PAPER ∧ Contrast]
and
[PAPER ∨ Contrast]
keys to adjust the
reference temperature.
Press the
[ENTER]
key to confirm the reference temperature setting.
NOTE
The WRM will calculate the equivalent resistance value at this new
temperature. Please see section 4.2 for further information about how this
value is calculated.
i. The following screen will be displayed:
Press any key to continue.
j. The following screen will be displayed:
Set the LTC or Voltage Regulator tap position as indicated on the LTC screen and press
the
[START]
key.
SET TAP TO 3 LOWER
“START” TO RUN TEST
OR
“STOP” TO ABORT
********WARNING******
DANGEROUS FLASH-OVER
WILL OCCUR IF CABLES
ARE DISCONNECTED!
D.U.T. TEMP
25.0
°C 77.0°F
↑↓ to adjust temp
“ENTER” to accept
REFERENCE TEMP:
85.0
°C 185.0°F
↑↓ to adjust temp
“ENTER” to accept