Vanguard WRM-40 - Manual (Page 53)

REV 3 WRM-10P AND WRM-40 USER’S MANUAL
49
3.9.3. Printing a Test Record Directory
A directory of all the test records stored in the WRM’s Flash EEPROM can be printed on the
built-in thermal printer using the steps below:
a. Start from the “START-UP” menu:
Press the
[2]
key (SETUP).
b. The following screen will be displayed:
Press the [3] key (RESTORE RECORD).
c. The following screen will be displayed:
Press the [2] key (DIRECTORY).
d. The following screen will be displayed:
Press the
[1]
key (FULL DIRECTORY) to print the entire directory of test records. After
the directory is printed, you will be returned to the “START-UP” menu.
Press the
[2]
key (SHORT DIRECTORY) to print a short directory. This lists the last 10
records stored in the WRM’s memory. After the directory is printed, you will be
returned to the “START-UP” menu.
A typical test record directory printout is shown in Figure 17.
PRINT DIRECTORY
1. FULL DIRECTORY
2. SHORT DIRECTORY
1. RESTORE RECORD
2. DIRECTORY
3. ERASE RECORDS
1. ENTER XFMR ID
2. REVIEW RECORD
3. RESTORE RECORD
4. NEXT PAGE
1. TEST XFMR 11/02/09
2. SETUP 12:33:01
3. USER DIAG