Vanguard WRM-40 - Manual (Page 21)

REV 3 WRM-10P AND WRM-40 USER’S MANUAL
17
3.3 Entering Test Record Header Information
You can enter the test record header information before performing tests. The record header
includes identifying information such as the company, station, circuit, model number, etc. Once
the header information has been entered, it will apply to all subsequent test records. To enter
the header information:
a. Start from the “START-UP” menu:
Press the [2] key (SETUP).
b. The following screen will be displayed:
Press the [1] key (ENTER XFMR ID).
c. The following screen will be displayed:
Type the company name using the alpha-numeric keypad.
When pressing a key, the corresponding number on the key will be displayed first.
Pressing the key again will display the first letter on the key. Pressing the key again will
display the second letter on the key. For example, to type the letter “A”, you must press
the
[2] key twice. To erase the character at the cursor position, press the [CLEAR] key.
Press the [PAPER ∧ Contrast] key to move to the next character. Press the [PAPER
∨ Contrast] key to move to the previous character. Press the [ENTER] key when you
are done typing the company name.
d. The following screen will be displayed:
Type the station name using the alpha-numeric keypad and then press the [ENTER]
key.
STATION:
UP/DOWN TO POSITION
“ENTER” TO ACCEPT
COMPANY:
UP/DOWN TO POSITION
“ENTER” TO ACCEPT
1. ENTER XFMR ID
2. REVIEW RECORD
3. RESTORE RECORD
4. NEXT PAGE
1. TEST XFMR 11/02/09
2. SETUP 12:33:01
3. USER DIAG