5 replacing the backlight, 5 replacing the backlight -8, Replacing the backlight – Proface APL3000B - Node Box PC User Manual

Page 147: 8 7.5 replacing the backlight

Advertising
background image

PS-3650A / PS-3651A User Manual

7-8

7.5

Replacing the Backlight

PS-A units use a CFL, long-life type backlight. The actual life of the backlight however, will vary depending

on the PS-A’s operating conditions. It is recommended that it be replaced periodically. A PS-A backlight has a

life of 50,000 hours (approx. 5.7 years, at 25°C and 24 hour operation), when the backlight is lit continuously

(time required for brightness to fall to half its normal level.)

„ Preparation

Please have the following ready beforehand.

Replacement backlight (Model:CA5-BLU12XGA-01)

One pair of clean (preferably new) cotton gloves.

Phillips screwdriver (no.2)

When the LED setting is specified with the RAS control in Control Panel and a backlight

burnout is detected, the status LED illuminates in orange.

If the backlight or the display unit is damaged, the screen display will go out. Even if the screen

goes out, however, there is a possibility that the touch panel is still operating correctly.

Therefore, since any type of touch panel contact could have an unexpected or dangerous effect

or result, be sure not to touch the screen when this condition occurs.

A backlight burnout is detected by monitoring the consumed current. Depending on the

condition of the backlight, a backlight burnout may not be detected or it may be detected before

the backlight burns out completely.

Whenever changing the backlight, be sure the PS-A’s power cord has been disconnected and that the unit

is cooled down.

High voltage runs through the wires in the backlight area. When the PS-A’s power cord is connected and

the PS-A is ON, do not touch the area!

When the PS-A’s power has just been turned OFF, the backlight area is still very hot! Do not touch the

backlight area until the area is cooled down. Be sure to wear gloves to prevent being burned.

The backlight is very fragile. Do not strongly push the glass tube or do not strongly pull it when replacing

the Backlight. If the glass tube breaks, you may be injured.

Advertising