Proface APL3000B - Node Box PC - Manual (Page 86)

Chapter 4 System Setup
4-27
4.2.4 Security
Supervisor Password Is
Displayed as “Set” when the password is set. Since no password has been set at factories, the factory default
setting is [Clear].
User Password Is
Displayed as “Set” when the password is set. Since no password has been set at factory, the factory default
setting is [Clear]. Note that BIOS setting is not allowed with a User Password.
Set Supervisor Password / Set User Password
Specifies a password. When any password is not needed, do not input any values in the new password setting
and press just the [Enter] key.
Fixed disk boot sector
Specifies whether writing into the boot sector on the hard disk is not allowed. Select from [Normal], [Write
Protect], or [Protect]. The factory default setting is [Normal].
Password on boot
Specifies whether a password should be needed at the Start-Up. The choice is [Enabled] or [Disabled]. The
factory default setting the is [Disabled].