1 problems and countermeasures, 1 problems and countermeasures -2, 2 8.1 problems and countermeasures – Proface APL3000B - Node Box PC User Manual
Page 157
PS-3650A / PS-3651A User Manual
8-2
8.1
Problems and Countermeasures
Problem
Countermeasure and reference page
Nothing appears on the screen.
Is the power cable connected properly?
Is the power supply/voltage within the range of the
specifications?
Is the backlight lit? If the backlight is burnt out, replace it.
Does the status LED illuminate in green?
Is the image output cable connected correctly?
Did you reconnect the image output cable and restart the
PS-A unit?
Did you disconnect the image output cable after starting
the PS-A unit?
- If the OS setup is not yet completed
Connect the image output cable correctly, and recover the
OS using the Recovery Media.
- If the OS setup is completed
• If the analog RGB cable is connected correctly
ÆHold down [Ctrl] + [Alt] + [F1] at the same time for 1
second or longer.
• If the DVI cable is connected correctly
ÆHold down [Ctrl] + [Alt] + [F4] at the same time for 1
second or longer.
The OS does not operate
properly.
Is [Type] in [Primary Slave] set to [Auto] in the IDE
setting?
Did you connect a new hard disk drive or commercial
USB memory which does not require boot-up?
If this symptom occurs, setting [Power on Delay] to
[Enabled] may solve the problem.
SEE
3 Hardware Installation (page3-1)
SEE
2.1 General Specifications (page2-2)
SEE
7.5 Replacing the Backlight (page7-8)
SEE
If the status LED does not illuminate, contact your
local PS-A distributor.
SEE
Primary Master / Primary Slave (page4-5)
SEE
SEE