Proface APL3000B - Node Box PC - Manual (Page 68)

Chapter 4 System Setup
4-9
„ Advanced Chipset Control
Point the cursor to the [Advanced Chipset Control] on the [Advanced] screen and press the [Enter] Key, so
that the following screen will be displayed.
DDR SDRAM Configuration
Point the cursor to the [DDR SDRAM Configuration] and press the [Enter] Key, so that you can go to the
Memory Setting screen.
ECC Config
Specifies whether the ECC function for memory, which is a function of recovering errors, needs to be used.
This parameter is displayed only when memory with the ECC function is used. Select from [ECC] or
[Disabled]. The factory default setting is [Disabled].
ECC Error Type
Specifies the interruption setting when an ECC error occurs. This parameter is displayed only when memory
with the ECC function is used. Select from [None], [NMI], [SMI], or [SCI]. The factory default setting is
[SMI].
SERR signal condition
Specifies error bit(s) for ECC. This parameter is displayed only when memory with the ECC function is used.
Select from [None], [Single bit], [Multiple bit], or [Both]. The factory default setting is [Both].
SEE
‹
DDR SDRAM Configuration (page4-10)