Yokogawa ADMAG CA - Manual (Page 35)

IM 1E8B0-01E
5-6
5. BASIC OPERATING PROCEDURES
Item Display Content
SET SHIFT INC
SET SHIFT INC
SET SHIFT INC
Press the SET key twice to enter data.
(All data will start flashing when the key is pressed the first time.
Then wait 2 to 3 seconds before pressing the key the second time.)
Hold down the SHIFT key and press the SET key to switch to
the flow rate data display.
➃ Data Input
➄ Switching to Flow
Data Entry
First time
Second time
%
(3) Procedures for Changing Decimal Place
Before starting this procedure check in the data list if the position of the decimal point
for the desired parameter decimal places can be changed.
Item Display Content
SET SHIFT INC
Press the SHIFT key to move the flashing segment to the decimal
point.
① Selecting
Decimal
Point
SET SHIFT INC
Press the INC key to move the decimal point to the right.
➁ Moving
Decimal
Point
SET SHIFT INC
Press the SET key twice to enter data.
(All data will start flashing when the key is pressed the first time.
Then wait 2 to 3 seconds before pressing the key the second tme.)
➂ Data Entry
SET SHIFT INC
First time
Second time
Example of parameter change : Changing the span from 1.000 to 10.00