Brocade Virtual ADX Switch and Router Guide (Supporting ADX v03.1.00) - Manual (Page 162)

148 Brocade Virtual ADX Switch and Router Guide
53-1003246-01
Displaying OSPF information
6
• show ip ospf database external-link-state advertise num – This command displays the data in
the packet for the specified external LSA.
For example, to determine an external LSA's index number, enter the following command.
Displaying OSPF virtual neighbor information
To display OSPF virtual neighbor information, enter the following command at any CLI level.
Virtual ADX show ip ospf virtual-neighbor
Syntax: show ip ospf virtual-neighbor [num]
The num parameter displays the table beginning at the specified entry number.
Displaying OSPF virtual link information
To display OSPF virtual link information for the router, use one of the following methods.
Virtual ADX show ip ospf virtual-link
Syntax: show ip ospf virtual-link [num]
The num parameter displays the table beginning at the specified entry number.
Displaying OSPF ABR and ASBR information
To display OSPF ABR and ASBR information, enter the following command at any CLI level.
Virtual ADX show ip ospf border-routers
Syntax: show ip ospf border-routers [ip-addr]
The ip-addr parameter displays the ABR and ASBR entries for the specified IP address.
Displaying OSPF trap status
All traps are enabled by default when you enable OSPF. To disable or re-enable an OSPF trap, refer
to
“Modify OSPF traps generated” on page 134.
Virtual ADX show ip ospf database external-link-state
Index Aging LS ID Router Seq(hex) Chksum
1 1332 10.132.81.208 10.130.130.241 80000002 000085ae
2 1325 10.132.116.192 10.130.130.241 80000002 0000a37d
3 1330 10.132.88.112 10.130.130.241 80000002 0000fb91
4 1333 10.132.75.48 10.130.130.241 80000002 00000ecc
5 1338 10.132.46.224 10.130.130.241 80000002 000067df
additional entries omitted for brevity...