Displaying bgp4+ summary – Brocade Virtual ADX Switch and Router Guide (Supporting ADX v03.1.00) User Manual

Page 371

Advertising
background image

Brocade Virtual ADX Switch and Router Guide

357

53-1003246-01

Displaying BGP4+ information

9

Displaying BGP4+ summary

To view summary BGP4+ information for the Virtual ADX device, enter the following command at
any level of the CLI.

Syntax: show ipv6 bgp summary

This display shows the following information.

NLRIs Sent in Update Message

The number of NLRIs for new routes the Virtual ADX device has sent to this
neighbor in UPDATE messages:

Withdraws – The number of routes the Virtual ADX device has sent to the
neighbor to withdraw.

Replacements – The number of routes the Virtual ADX device has sent to
the neighbor to replace routes the neighbor already has.

Peer Out of Memory Count for

Statistics for the times the Virtual ADX device has run out of BGP4+ memory
for the neighbor during the current BGP4+ session:

Receiving Update Messages – The number of times UPDATE messages
were discarded because there was no memory for attribute entries.

Accepting Routes(NLRI) – The number of NLRIs discarded because there
was no memory for NLRI entries. This count is not included in the
Receiving Update Messages count.

Attributes – The number of times there was no memory for BGP4+
attribute entries.

Outbound Routes (RIB-out) – The number of times there was no memory
to place a “best” route into the neighbor's route information base
(Adj-RIB-Out) for routes to be advertised.

Outbound Routes Holder – For debugging purposes only.

TABLE 22

BGP4+ summary information

This field...

Displays...

Router ID

The Virtual ADX device’s router ID.

Local AS Number

The BGP4+ AS number in which the Virtual ADX device resides.

Maximum Number of
Paths Supported for Load
Sharing

The maximum number of route paths across which the Virtual ADX device can
balance traffic to the same destination. The feature is enabled by default but
the default number of paths is 1. You can increase the number from 2 – 8
paths.

Number of Neighbors
Configured

The number of BGP4+ neighbors configured on this Virtual ADX device.

TABLE 21

BGP4+ neighbor route summary information (Continued)

This field...

Displays...

Virtual ADX# show ipv6 bgp summary

BGP4 Summary

Router ID: 10.223.223.223 Local AS Number : 65001

Maximum Number of Paths Supported for Load Sharing : 1

Number of Neighbors Configured : 1

Number of Routes Installed : 2

Number of Routes Advertising to All Neighbors : 2

Number of Attribute Entries Installed : 1

Neighbor Address AS# State Time Rt:Accepted Filtered Sent ToSend

2001:db8:2000:4::110 65002 ESTAB 21h32m32s 0 0 2 0

Advertising