Brocade Virtual ADX Switch and Router Guide (Supporting ADX v03.1.00) - Manual (Page 60)

46 Brocade Virtual ADX Switch and Router Guide
53-1003246-01
Displaying VLAN information
3
Syntax: show vlans [vlan-id | ethernet portnum]
The vlan-id parameter specifies a VLAN for which you want to display the configuration information.
The ethernet portnum parameter specifies a port. If you use this parameter, the command lists all
the VLAN memberships for the port.
Using show run to display VLAN information
.You can use the show running-config command to display information for VLANs and VLAN groups.
The show running-config command displays VLANs in the order they were configured on the device.
Device running Enterprise software release 08.0.00 and later displays VLANs in numerical order
(for example, VLAN 100, VLAN 200, and so on in the show running-config output.
Virtual ADX(config)# show vlans e 7/1
Total PORT-VLAN entries: 3
Maximum PORT-VLAN entries: 8
legend: [S=Slot]
PORT-VLAN 100, Name [None], Priority level0, Spanning tree Off
Untagged Ports: (S7) 1 2 3 4
Tagged Ports: None
IP-subnet VLAN 10.95.11.0 255.255.255.0, Dynamic port disabled
Static ports: (S7) 1 2
Exclude ports: None
Dynamic ports: None