Brocade Virtual ADX Switch and Router Guide (Supporting ADX v03.1.00) - Manual (Page 307)

Brocade Virtual ADX Switch and Router Guide 293
53-1003246-01
Displaying BGP4 information
8
Displaying advertised routes
To display the routes the device has advertised to a specific neighbor for a specific network, enter a
command such as the following at any level of the CLI.
You also can enter a specific route.
Syntax: show ip bgp neighbor ip-addr advertised-routes [ip-addr/prefix]
For information about the fields in this display, refer to Table 42 . The fields in this display also
appear in the show ip bgp display.
Displaying the routes with destinations that are unreachable
To display BGP4 routes with destinations that are unreachable using any of the BGP4 paths in the
BGP4 route table, enter a command such as the following at any level of the CLI:
Virtual ADX(config-bgp)# show ip bgp neighbor 192.168.4.211 routes unreachable
Syntax: show ip bgp neighbor ip-addr routes unreachable
For information about the fields in this display, refer to Table 42 . The fields in this display also
appear in the show ip bgp display.
NLRIs Sent in Update Message The number of NLRIs for new routes the device has sent to this neighbor
in UPDATE messages:
•
Withdraws – The number of routes the device has sent to the
neighbor to withdraw.
•
Replacements – The number of routes the device has sent to the
neighbor to replace routes the neighbor already has.
Peer Out of Memory Count for Statistics for the times the device has run out of BGP4 memory for the
neighbor during the current BGP4 session:
•
Receiving Update Messages – The number of times update
messages were discarded because there was no memory for
attribute entries.
•
Accepting Routes (NLRI) – The number of NLRIs discarded because
there was no memory for NLRI entries. This count is not included in
the Receiving Update Messages count.
•
Attributes – The number of times there was no memory for BGP4
attribute entries.
•
Outbound Routes (RIB-out) – The number of times there was no
memory to place a “best” route into the neighbor route information
base (Adj-RIB-Out) for routes to be advertised.
TABLE 42 BGP4 route summary information for a neighbor (Continued)
This field... Displays...
Virtual ADX# show ip bgp neighbors 192.168.4.211 advertised-routes
There are 2 routes advertised to neighbor 192.168.4.211
Status A:AGGREGATE B:BEST b:NOT-INSTALLED-BEST I:IBGP L:LOCAL
Network Next Hop Metric LocPrf Weight Status
1 10.0.0.0/24 192.168.2.102 12 32768 BL
2 10.1.1.0/24 192.168.2.102 0 32768 BL
Virtual ADX# show ip bgp neighbors 192.168.4.211 advertised 10.1.1.0/24
Status A:AGGREGATE B:BEST b:NOT-INSTALLED-BEST I:IBGP L:LOCAL
Network Next Hop Metric LocPrf Weight Status
1 10.1.1.0/24 192.168.2.102 0 32768 BL