Brocade Virtual ADX Switch and Router Guide (Supporting ADX v03.1.00) - Manual (Page 50)

36 Brocade Virtual ADX Switch and Router Guide
53-1003246-01
Routing between VLANs
3
Syntax: vlan vlan-id by port
Syntax: untagged ethernet portnum [to portnum | ethernet portnum]
Modifying a port-based VLAN
You can make the following modifications to a port-based VLAN:
• Add or delete a VLAN port.
• Change its priority.
• Enable or disable STP.
Removing a port-based VLAN
Suppose you want to remove VLAN 5 for example. To do so, use the following procedure.
1. Access the global CONFIG level of the CLI on by entering the following commands.
Virtual ADX-A enable
No password has been assigned yet...
Virtual ADX-A# configure terminal
Virtual ADX-A(config)#
2. Enter the following command.
Virtual ADX-A(config)# no vlan 5
Virtual ADX-A(config)#
3. Enter the following commands to exit the CONFIG level and save the configuration to the
system-config file on flash memory.
Virtual ADX-A(config)#
Virtual ADX-A(config)# end
Virtual ADX-A# write memory
Virtual ADX-A#
4. Repeat steps 1 – 3 on Virtual ADX-B.
Syntax: no vlan vlan-id by port
Removing a port from a VLAN
Suppose you want to remove port 11 from VLAN 4 on Virtual ADX-A for example. To do so, use the
following procedure.
1. Access the global CONFIG level of the CLI on Virtual ADX-A by entering the following command.
Virtual ADX-A enable
No password has been assigned yet...
Virtual ADX-A# configure terminal
Virtual ADX-A(config)#
2. Access the level of the CLI for configuring port-based VLAN 4 by entering the following
command.
Virtual ADX-A(config)#
Virtual ADX-A(config)# vlan 4
Virtual ADX-A(config-vlan-4)#