Brocade Virtual ADX Switch and Router Guide (Supporting ADX v03.1.00) - Manual (Page 364)

350 Brocade Virtual ADX Switch and Router Guide
53-1003246-01
Displaying BGP4+ information
9
Displaying the Adj-RIB-Out for a BGP4+ neighbor
You can display a summary or detailed information about the following:
• All routes in a Virtual ADX device’s current BGP4+ Routing Information Base (Adj-RIB-Out) for a
specified neighbor.
• A specified route in a Virtual ADX device’s current BGP4+ RIB for a specified neighbor.
The RIB contains the routes that the Virtual ADX device either has most recently sent to the
neighbor or is about to send to the neighbor.
For example, to display a summary of all routes in a Virtual ADX device’s RIB for neighbor
2001:db8:2000:4::110, enter the following command at any level of the CLI.
Syntax: show ipv6 bgp neighbor ipv6-address rib-out-routes [ipv6-prefix/prefix-length | detail
[ipv6-prefix/prefix-length network-mask]]
The ipv6-address parameter displays the RIB routes for a specified neighbor. You must specify this
address in hexadecimal using 16-bit values between colons as documented in RFC 2373.
The ipv6-prefix/prefix-length parameter displays the specified RIB route for the neighbor. You must
specify the ipv6-prefix parameter in hexadecimal using 16-bit values between colons as
documented in RFC 2373. You must specify the prefix-length parameter as a decimal value. A slash
mark (/) must follow the ipv6-prefix parameter and precede the prefix-length parameter.
The detail ipv6-prefix/prefix-length network-mask parameter displays detailed information about
the specified RIB routes. If you do not specify this parameter, a summary of the RIB routes displays.
You must specify the ipv6-prefix parameter in hexadecimal using 16-bit values between colons as
documented in RFC 2373. You must specify the prefix-length parameter as a decimal value. A slash
mark (/) must follow the ipv6-prefix parameter and precede the prefix-length parameter. You must
specify the network-mask parameter using 8-bit values in dotted decimal notation.
Adj RIB out count The number of routes in the Virtual ADX device’s current BGP4+ Routing
Information Base (Adj-RIB-Out) for a specified neighbor.
Admin distance The administrative distance of the route.
TABLE 16 Detailed route information received from a BGP4+ neighbor (Continued)
This field... Displays...
Virtual ADX# show ipv6 bgp neighbor 2001:db8:2000:4::110 rib-out-routes
There are 2 RIB_out routes for neighbor 2001:db8:2000:4::110
Status A:AGGREGATE B:BEST b:NOT-INSTALLED-BEST E:EBGP I:IBGP L:LOCAL
Prefix Next Hop Metric LocPrf Weight Status
1 2001:db8:2002:1234::/32 :: 1 100 32768 BL
AS_PATH:
2 2001:db8:2002::/16 :: 1 100 32768 BL
AS_PATH: