Displaying ipsec for an interface – Brocade Virtual ADX Switch and Router Guide (Supporting ADX v03.1.00) User Manual
Page 192
178
Brocade Virtual ADX Switch and Router Guide
53-1003246-01
Enabling OSPFv3
7
Displaying IPsec for an interface
To see IPsec configuration for a particular interface or all interfaces, use the show ipv6 ospf
interface command as in the following example (IPsec information in bold).
TABLE 21
Area configuration of IPsec
This field...
Displays...
Authentication
This field shows whether or not authentication is configured. If this field says
“Not Configured,” the IPsec-related fields (bold in example screen output) are
not displayed at all.
KeyRolloverTime
The number of seconds between each initiation of a key rollover. This field
shows the configured and current times.
KeyRolloverState
Can be:
Not active: key rollover is not active
Active phase 1: rollover is in its first interval.
Active phase 2: rollover is in its second interval.
Current
Shows current SPI, authentication algorithm (currently ESP only), encryption
algorithm (currently SHA1 only), and the current key.
New
Shows new SPI (if changed), authentication algorithm (currently ESP only),
encryption algorithm (currently SHA1 only), and the new key.
Old
Shows old SPI (if changed), authentication algorithm (currently ESP only),
encryption algorithm (currently SHA1 only), and the old key.