Brocade Virtual ADX Switch and Router Guide (Supporting ADX v03.1.00) - Manual (Page 334)

320 Brocade Virtual ADX Switch and Router Guide
53-1003246-01
Displaying BGP4+ information
9
The ipv6-address parameter specifies a neighbor by its IPv6 address. You must specify this address
in hexadecimal using 16-bit values between colons as documented in RFC 2373.
Specify the flap-statistics keyword to clear route flap dampening statistics for the specified
neighbor.
Clearing and resetting BGP4+ routes in the IPv6 route table
You can clear all BGP4+ routes or only those routes associated with a particular IPv6 prefix from
the IPv6 route table and reset the routes. When cleared, the BGP4+ routes are removed from the
IPv6 main route table and then restored again.
For example, to clear all BGP4+ routes and reset them, enter the following command at the
Privileged EXEC level or any of the Config levels of the CLI.
Virtual ADX# clear ipv6 bgp routes
Syntax: clear ip bgp routes [ipv6-prefix/prefix-length]
The ipv6-prefix/prefix-length parameter clears routes associated with a particular IPv6 prefix. You
must specify the ipv6-prefix parameter in hexadecimal using 16-bit values between colons as
documented in RFC 2373. You must specify the prefix-length parameter as a decimal value. A slash
mark (/) must follow the ipv6-prefix parameter and precede the prefix-length parameter.
Clearing traffic counters for all BGP4+ neighbors
To clear the message counters (reset them to 0) for all BGP4+ neighbors, enter the following
command.
Virtual ADX(config)# clear ipv6 bgp traffic
Syntax: clear ipv6 bgp traffic
Displaying BGP4+ information
You can display the following BGP4+ information:
• BGP4+ route table.
• BGP4+ route information.
• BGP4+ route-attribute entries.
• BGP4+ configuration information.
• Dampened BGP4+ paths.
• Filtered-out BGP4+ routes.
• BGP4+ route flap dampening statistics.
• BGP4+ neighbor information.
• BGP4+ summary information.