Brocade Virtual ADX Switch and Router Guide (Supporting ADX v03.1.00) - Manual (Page 305)

Brocade Virtual ADX Switch and Router Guide 291
53-1003246-01
Displaying BGP4 information
8
Displaying route information for a neighbor
You can display routes based on the following criteria:
• A summary of the routes for a specific neighbor.
• Routes received from the neighbor that the device selected as the best routes to their
destinations.
• Routes received from the neighbor that are the best BGP4 routes to their destinations, but
were not installed in the IP route table because the device received better routes from other
sources (such as OSPF, or static IP routes).
• Routes that are unreachable because the device does not have a valid OSPF, or static route to
the next hop.
• Routes for a specific network advertised by the device to the neighbor.
• The Routing Information Base (RIB) for a specific network advertised to the neighbor. You can
display the RIB regardless of whether the device has already sent it to the neighbor.
Displaying summary route information
To display summary route information, enter a command such as the following at any level of the
CLI.
This display shows the following information.
SendQue The number of sequence numbers in the send queue.
RcvQue The number of sequence numbers in the receive queue.
CngstWnd The number of times the window has changed.
TABLE 41 BGP4 neighbor information (Continued)
This field... Displays...
Virtual ADX(config-bgp)# show ip bgp neighbor 10.1.0.2 routes-summary
1 IP Address: 10.1.0.2
Routes Accepted/Installed:1, Filtered/Kept:11, Filtered:11
Routes Selected as BEST Routes:1
BEST Routes not Installed in IP Forwarding Table:0
Unreachable Routes (no IGP Route for NEXTHOP):0
History Routes:0
NLRIs Received in Update Message:24, Withdraws:0 (0), Replacements:1
NLRIs Discarded due to
Maximum Prefix Limit:0, AS Loop:0
Invalid Nexthop:0, Invalid Nexthop Address:0.0.0.0
Duplicated Originator_ID:0, Cluster_ID:0
Routes Advertised:0, To be Sent:0, To be Withdrawn:0
NLRIs Sent in Update Message:0, Withdraws:0, Replacements:0
Peer Out of Memory Count for:
Receiving Update Messages:0, Accepting Routes(NLRI):0
Attributes:0, Outbound Routes(RIB-out):0