Agilent Technologies E5810A - Manual (Page 139)

Appendix B 139
Using the Telnet Utility
Using the Telnet Utility
Typical Telnet
Screen Display
A typical display screen for an E5810 follows. The configuration values you
see for your E5810 will probably be different from those shown.
Welcome to the E5810 LAN/GPIB Gateway Configuration Utility.
Controls GPIB and RS-232 interfaces via the LAN
Commands
?
exit, quit
reboot
status View Available Commands
Exit WITHOUT Saving Configuration Changes (see reboot)
Save Configuration Changes and Restart E5810
View the LAN/GPIB Gateway Connection Status
Read-only E5810 Parameters
hardware-addr:
serial-num: 0030D305001E
US12341234 # Ethernet (MAC) Address
# Serial Number
Configurable Parameters saved in E5810 non-volatile memory
(Note: Some E5810 current values “in-use” may be different)
dhcp:
ip:
subnet-mask:
gateway:
dns-server
hostname:
OFF
156.140.104.232
255.255.254.0
156.140.104.1
156.140.2.11
my1234567 # Configure LAN for DHCP boot
# Internet Protocol (IP) Address
# Network Subnet Mask
# Network Gateway
# DNS Server
# Internet Hostname
description: Agilent E5810 (00-30-D3-05-00-1E)
# Device Description (UPnP Friendly Name)
upnp:
lan-timeout:
io-timeout:
gpib-name:
gpib-address:
gpib-unit:
rs232-name:
rs232-baud:
rs232-bits:
rs232-stopbits:
rs232-parity:
rs232-flow:
rs232-srq:
ON
600
120
gpib0
21
7
COM1
9600
8
1
NONE
NONE
RI
# Configured as UPnP device
# LAN Timeout (Keepalive) in sec
# I/O Timeout in seconds
# GPIB SICL Interface Name
# GPIB System Controller Address
# GPIB Logical Unit (LU) Number
# RS-232 SICL Interface Name
# RS-232 Baud Rate
# RS-232 Bits
# RS-232 Stop Bits
# RS-232 Parity
# RS-232 Flow Control
# RS-232 SRQ